pdf versions of our artificial grass fitting guide Download pdf version of our artificial grass fitting guide, a handy quick reference guide whilst you fit your artificial grass.

TOOLS YOU WILL NEED
  1. Glue spreader: to spread the glue evenly
  2. Stanley knife: for cutting the artificial grass to the exact size
  3. Brush or broom: for brushing the artificial grass straight
MATERIALS YOU WILL NEED
  1. Condor Grass artificial grass
  2. Geo-Textile: stabilises the surface underneath the artificial grass
  3. Glue for artificial grass: for glueing the joins in the artificial grass
  4. Grass seaming tape: for quick and easy glueing of joins in the artificial grass
  5. Ties for artificial grass: to fasten the artificial grass more securely
  6. Silica sand: sanding down the artificial grass down provides added stability for the mat and extra protection for the artificial grass fibres.
INSTRUCTIONS

Before laying the artificial grass always make a plan to ensure you are aware of where any joins maybe and how much artificial grass you will actually need.

STEP 1

Remove any old grass, dig out 5cm (2”), level the surface and spread a substantial layer of building sand across the surface (5 to 6 cm / 2”-2.5”).

STEP 2

Compact this layer of sand properly and sprinkle with water.

STEP 3

Level the sand so that you are left with a nice even surface.

STEP 4

Roll the geo-textile out and cut to size.

STEP 5

Roll out the artificial grass, making sure to even out any creases. The pile should point towards the spot from where you are most likely to view the grass.

NOTE

Check the artificial grass for any production defects

For surfaces that exceed more than 4 m you will have a join. If this is not the case, go to Step 6 *

If the temperature drops, it’s possible the artificial grass will shrink. The artificial grass may contract if it is laid during the day when temperatures are between 20 to 25 degrees Celsius and it cools to 17 degrees Celsius in the evening. We would advise when you lay the artificial grass so that you leave 2 to 3 centimetres extra in length.

STEP 6

If you do need to make a join, pull back the artificial grass and make a join between the two rolls with a Stanley knife. The black backing to which the artificial grass fibres are attached will protrude a little on both sides. These sides must be cut away.

STEP 7

Roll out the next strip of artificial grass and repeat the same process as for the first strip of artificial grass. Lay both pieces together and check that they are properly aligned and no join can be seen (the width of the join between the two strips should be no more than 4 mm).

installation-artificial-grass

STEP 8

Pull back both pieces and apply the artificial grass seaming tape or the adhesive tape directly under the join

STEP 9

Lay both pieces of artificial grass together again and carefully apply pressure to the glue with your hands on the backing of the artificial grass.

STEP 10

Repeat the steps above until all the artificial grass is in place.

* Cut the edges to the required shape/outline.

fitting-artificial-grass-corners

STEP 11

To enhance the wear and appearance of your Condor Grass we recommend you to spread silica sand onto the artificial grass (5kg per m2).

STEP 12

Remove all the left-over pieces and brush the artificial grass with a brush or broom.

Other Guides

Other guides you  may  like …